Search results

Good Morning all! I apologize for the delay in posting my follow-up to this thread and resolution to my starting issue. Good news, Motogiro, I finally got my new part, the Starter Interrupt - Cut off relay. This was the culprit for not getting any fuel and fire to the cylinders from the...

Thank you everyone for your insights and replies. As Motogiro suggested, I grounded the neutral switch and the light comes on so I have ordered the starter cut-off relay. I was unable to check it with my meter, but based on what other electrical functions are known to go through this relay, it...

When I disconnect the lean angle sensor, fuel pump doesn't prime and then does when I turn the key so based on this I would think the sensor is good. Anybody else got any suggestions? Again, I have no power to the starter when the starter switch is engaged, new battery fully charged, starter...

The service manual gives directions on checking it at 65 degree angle, but I'm not sure I doing it right because my readings on volt meter gives a wide range.

swigley69 New Member kickstand up, clutch lever engaged, still in neutral or 1st gear and get nothing with starter switch. I have bypassed the kill switch and still nothing. When I use a jumper wire, the starter engages but no fire or fuel to the cylinders. Starter switch never engages the...

Do I have a bad neutral safety switch if the neutral light does not come on? Display lights up properly, fuel pump priming occurs, starter works when using a jumper wire, but I have no current to the starter from the starter switch. Any ideas?