Search results

Brand new and unopened. Never got around to fitting before i sold my bike. £10 Incl P&P

Brand new and unopened. Never got around to fitting before i sold my bike. £30 Incl P&P

Brand new and unopened. Never got around to fitting before i sold my bike. £10 Incl P&P

Just been out in the garage, stripped the faring off, checked relays and fuses.... all ok. So i start to wiggle the 2 multi plugs up front on the left hand side... bingo ! I managed to recreate the fault !. Upon closer inspection i found all the pins were corroded !. Gave them a file/clean...

Today on the way home.... IN THE DARK !!!, my headlights, sidelights and front indicators just stopped working. The full beam dash light (blue one) came on and stayed on until the headlights and front indicators just started working again :confused: Rear tail light, brake light and rear...

My forks were knackered so it'll probably be that. I've rebuilt them now, new springs (both), seals and fresh oil :thumbup: Thanks all

FYI, they are Michelin Pilot Road 2 tyres

Will check my tyre pressures when i get home but i'm sure they are normal

Not sure if you can see from the pics....

Hi all, During my last MOT they advised that my front tyre had uneven wear on it. I can see that the left side of the tyre has like flat spots. I'll try and get a pic soon. What would cause uneven wear on the front tyre ?

The brake calipers aren't iron, they're aluminium. The slider pins are steel.

The other brake caliper didn't break with the same torque wrench :confused:

Nope, no vice. I did all the work on my bench while it was loose. No clamps or anything. It doesn't bolt to anything. Its for the slider pins.

There wasn't any grease on the threads before, that's come from the slider pin as i pulled it out.

I did give it a little clean with a brush and some brake cleaner.... obviously not enough for some ;) I also cleaned the pistons and gave it a good blow with the air compressor. Nope, didn't drop it. It just broke as i was tightening it up to 40nm.

Never said i was cleaning it ;) That's 37k of dirt !! I only replaced the seals

Do you know if its possible to fit different calipers ? because look whats happened to my freshly re-sealed caliper ! :( Do you know if the other Fazer, earlier and later model calipers fit straight on ?

Nooooooooooooooooooooooooooooooooooooooooooo :( Look whats happened to my freshly re-sealed caliper ! :(

Thanks but i managed with an air gun and compression from the spring. I must say tho, i am liking the naked look a lot :thumbup:

Suspension rebuild. New seals, springs (both) and oil :rockon: No turbo :( Just haven't trouble getting the damper bolt out of the bottom :confused: