Search results

I have Ohm'ed both G/W and ground wire from inside the fuel pump to the connector at the instrument and both are around 1 Ohm.....

I "solved" it by soldering a 70 ohm resistor in parallel with the meter. The instrument now show a flashing bar when it is near empty and all but one bar when is is full. It's better than having one flashing bar when there is 15 liters left and after that the error signal. Not the ideal way to...

Hi Skyworm. Can you tell from your broken parts how one is supposed to open it? I wan't to open mine but I'm afraid to break it.

If you have a multimeter you can measure the resistance on the sensor. If it is between 20 and 140 ohms the instrument should not show the error. You could also check the connector to the instrument. I suspect the error on my bike is either a bad ground wire to the sensor or instrument, or...

Thanks! The flat battery incident was a month ago so the battery is recharged now. :) I read in the forum that it was recommended to disconnect the battery for 15 minutes. I also read in the forum that fault codes was not erased by disconnecting the battery but I'll might as well give it a...

I just installed this one: 45 High Power SMD LED 1156/1157 Tower Bulb Specifications The red version is only 120 lumen, but to me it looked about as bright as the old gas bulb. It works well with the reflector, you will have to look very closely to see that it is a LED in there. I see...

Hi I got the fuel meter error code. (All the bars flashes eight times). The sensor measures 20 ohms at full and 140 ohms at empty just as the manual says. Could it just be that the fault code needs to be erased? What else can I check? The trouble started after my battery got totally...