Search results

Could use a stock exhaust header from a 2007 or 2008. Anyone have one lying around after an exhaust upgrade? Thanks Dave

Thanks for the info. I just need the "headlight cord" so I can attatch my "meter" speedo/tach assy to my main wireharness.

Need headlite wireharness. Part#4s8-84359-20-00. Parts list say's a 2007/2008 are the same. Thanks Dave

Finally found a used meter for my golf car build. It was damaged, but with help from JB weld for plastic and a piece of Lexan, it will work for me. My problem is the main wireharness will not plug into the meter. Is there a "sub" harness? Been looking at parts lists and all I can think of is...

Anyone have a "nonworking" 2008 meter assy? Found a working unit, but the RPM lens and cases are damaged. Hope so, but if not, I'll just try some plastic fabbing. It's just for my golf car:D

Thanks guy's! No golfing with this....It's "Track Time", If I ever finish it. LOL

Not done yet...but getting there. Should be a blast to drive!

Anyone? Any ideas?

Bump....I'm still looking.

Will it work for a 2008 engine/wireing harness?

Looking for speedo/gauge cluster for a 2008. Thanks

I have a good "lefthand" frame half off a 2008. Woild that help? Let me know.

Is this what your looking for? It's off a 2008. Let me know.

Have a 2008 FZ6. Can anyone help with the number of splines and the outside diamater of the toothed shaft? Thanks

Bought "Alans" engine assy. I have some parts I don't need. Left hand frame halve, right hand side was broken in 2 places. Can send pic's. Steering shaft/yoke and bearings. Sorry not much else, but let me. This is going to be the fastest golf car...I hope. Dave

Thanks for the engine assy Alan. You where a pleasure to meet. If I ever get this project done.......It's going to be "killer"! Good luck in BC and the Olympic's project.

Fred..."You are the man"! Thanks so much. Another peice of the puzzel.

Thanks Fred and Cali Rider for you quick responce and nice words. As the "build" unfolds, I will post in the Non-FZ6 section. Fred, the service manual didn't happen to post the "PSI" reading in terms that I could understand, did it? I'm not shure what 250 kpa (2.5 kg/cm2) means in psi terms...

New to site, I'm going to be honest, I build custom golf cars. Picked up a 2008 FZ6 motor, complete with wire harness/header ect ect that I was able to hear it run. My question for you is the fuel pump pressure needed to run the EFI. I couldn't ask the seller for the fuel pump assy...