Recent content by vrtulnik

So guys, I found problem maybe. please see videos. I disconected spark plug caps from #4 to #1 cylinder - engine went on three cylinder. I stoped at #2 valve. When I disconected spark plug cap on #2 cylinder, engine sound was constant. So I exchanged #2 #3 wires and than I disconected #3 cap...

No, engine was not off. I measured temps when engine was turned on. I will try measure temps again, tomorrow.

Thank you very much. :) It will be hard get this tool to spark plug holes, because there is small space. I will make video with each cylinder, just i must wait for tester. I am thinking.. Is it possible that problem is in bad regulator, or stator and charging system?

Thank you. I ordered tester. If the ignition is OK, should the bulb flash?

Do you mean this tool?

as for measuring temps - Yes, I did measuring many times and bike was sputtering all the time. It is hard describe this situation. I am thinking about it already 2 months. The engine does not run correctly during idle speed, idle speed is fluctuate, all the time - engine is not running...

I meant this screw. (blue circle). 1 cylinder cooler: It was bad measure, because I first measured temps from left side of bike. I measured temp of #1 cylinder from outer side, and there was lower temp than #2 and #3 pipes and #4 from inner side. When I went measure from right side of bike...

no, boots are glued on air box from factory. You have it too. This glue was cracked and I gave there silicone... It is good now, 100% sealed... - I tried start bike without air box and sprayed brake cleaner - no sound change. - I changed all intake hoses and TBS hoses... I adjusted TBS screws...

Thank you. Is it possible start bike without airbox? I can connect temp sensor. I would like spray brake cleaner around throttle body boots and another intake hoses. - I checked air box boots, there was any glue, so I removed glue (because it was not tight) and I applied black silicone (for...

Hi, 1. valves adjusted - intake valves were 0.20 - 0.24, but left exhaust valve #4 was 0.38, ... Now, all valves are okay and adjusted!! 2. Carbon from intake valves - cleaned. 3. I had disassembled throttle body (where are 4 air (needles) screws). Needles were very dirty. Also I disassembled...

Yes, it is not good new for me. I am thinking few days how can I clean them without remove cylinder head.. 1. I will to pour Techron mixed with petrol (e.g. 1:5, or 1:10) into closed valves. 2. After 10-15 minutes I will try scrape carbon via brush. (I hope that valves will tight and liquid...

I am posting photos of intake valves. You can see how are dirty. Carbon is on all valves. ****Better view is on second photo. Question: When I have open intake valves on #1 cylinder, another intake valves should be complete closed? You can see on the second photo that valves on #2 cylinder...

Yes, now I understands, thank you :)

I read about CCT, i do not understand installation steps. (already after adjusted valve clearance) When is CCT removed, I need turn the tensioner rod fully clockwise with a thin screwdriver - whole rod will be in CCT housing. I will install the gasket and the timing chain tensioner onto the...

Do i need remove CCT? Because I read that during adjusting clearances is enough uncsrew adjust screw in CCT for chain release.