Recent content by tlucasbr

Uhmmm thats a good tip!! Two months ago, after I replaced the mid pipe (a MIVV no kat in place of the catalyst), I did disconnected the battery.. so it would reset the fuel map and create a new one; that time, after I re-plugged the battery, the flashing light came on.. and before that I had no...

I do remember of reading in some thread were was discussed about this kind of registry.. it seems like there's a "feature" that records like an history of excessive inclination, and that is saved in the ECU..... but in my case the engine was stopped, the key wasn't in the start position.. and...

Sure it will, Thanks !! This weekend I'll run some tests and post the results.

Unfortunately there are no fault codes.. just the flashing oil light (today has been one week since it last happened...). According to the Haynes I might have a short in this wiring.. I was just reading about a similar case with an R6 and his problem was a loose oil level switch.. not my...

Hm.. Can somebody with some expertise in electrical components clarify the following quote (from the Haynes manual), regarding the warning that I'm seeing with the blinking "Note: If there is a fault in the wiring circuit it will be detected by a self diagnosis function an the warning...

Whats up guys, I've been following the forum for a few months since I became a happy FZ6-N owner, and had the chance to learn a lot about my new bike.. now my time has come and its time for my first post, and tricky question ;) Few months ago I laid down my FZ6 just to see if the slider would...