I do not know
If the two pieces must be joined to make greater pressure or must be separated to avoid that the rubber is raised .
Only the photo of a user who has the same fuel pump same as mine will remove all doubt .
thanks
I have also sent a private message to BloodsweatnGears
I hope in your response.
I would just like to know if :
The piece of plastic must enter the piece of rubber ?
thanks
Thanks for the reply
I believe that the piece of plastic must be inserted into the rubber , but I'm not sure .
If someone has the fuel pump assembly can post the photo of the base which supports the pump motor .
thanks
The bike is a fz6 N 2004
Good evening everyone
I'm really desperate.
I ask your help.
I have a yamaha fz6 n 2004 and I disassembled the fuel pump.
When I removed the pump motor are also removed two pieces:
1 oring
1 piece of plastic
Now I can not more to replace the fuel pump.
These two pieces are to be united?
Will...
Good evening everyone
I'm really desperate.
I ask your help.
I have a yamaha fz6 n 2004 and I disassembled the fuel pump.
When I removed the pump motor are also removed two pieces:
1 oring
1 piece of plastic
Now I can not more to replace the fuel pump.
These two pieces are to be...