Recent content by smallblock450sl

Yamahauler FZ6 done!

Thanks for the heads up. Never tried to sell before and I didn't read the rules. I do learn from my mistakes.

Would like to sell as a lot, but will sell individually if wanted. Cat/clutch cable/throttle cables/front sprocket/sprocket cover plate/air diverter and hoses/shifter lever and linkage/5vx-82380-00-00 sensor,pressure/5vk-81950-30-00 relay assy/4bh-81940-02-00 starter relay assy. Make me an...

Have a few easy test drive's. Haven't "dropped" the clutch for a hard launch. The 5.00 gear's in the Ford 9" make 1st gear rather short. Don't have the room in our place to give it a good run out, but going thru 3 or 4 gears it just wants to "motivate":D Hope the bad video works...2013...

The clutch cover must have been taken off, the shaft gears where not "clocked" correctly with the pressure plate pull shaft. Did have to change to a Wilwood slave cylinder, the cheap one didn't have enough through. The video is in nuetral. Had the first seat time today, took it very easy (no...

Thanks for the reply. I have a hydrolic slave assy to actuate the clutch. The problem is the lever (moves 15 to 20mm) but there is no tension to it. I can freely move it with my finger. Just seems as though it's not pulling the pressure plate to release the clutch pack. Any more thoughts...

Has been a while. I did "fry" the ECU, but the used tank and fuel pump I bought, the fuel pump was bad also. Good used ECU and fuel pump and it fires up and sounds great! My problem now is the clutch won't work. Seems like the clutch shaft won't release the pressure plate. Tried the start...

Thank you.....That is exactly what I needed :thumbup:

Anyone have a picture of the lean angle sensor location/orintation on your bike? Thanks

Wow, thanks for the posts:thumbup: There's only one wire lead that attatches to the starter, can anyone tell me exactly where it attatch's at the battery area?

Well all done with frame/suspenssion/driveline/electrical. Put some fuel in, turned the ignition switch, turned on the fuel pump, pushed the start button....and "POP" goes the main 30 amp fuse:eek: Seems I put the battery in backwards:( Reinstalled the battery correctly, changed the fuse...

If anyone else needs one, I have one off a 2008.

Is the Speedo still available?

Still have the mufler and cover for sale?

Still for sale?