Recent content by rrgcsfb

Thanks guys. I bit the bullet and picked up the plug and crush washer at dealer. $7.00 for both. Expensive, but piece of mind.

Hi - I've been looking everywhere and can't find information on the size of the oil drain bolt. Mine went missing during an oil change (don't ask) and will try to find a replacement tomorrow at autozone, pep boys etc. Can somebody please tell me what the drain bolt is? TIA

Thanks all for the advice and feedback. I'm searching for the nearest indy shop tonight. RRG

LOL! That would be something!!

Hi, My new tires have arrived, and taking the rims off this weekend to change the rubber. Does anybody know if I have to take the rims to a "motorcycle shop" to have the rubber removed/installed, or can I go to any car garage that changes tires? In other words, is special equipment used...

I went with the ROX Speed Fx Anti-Vibration risers. Their design allows for pivoting at 2 places, allowing for more adjustment. They fit without having to lengthen any cables, but I can't say much for the anti-vibration feature. Rox Speed Fx Anti-Vibration Handlebar Risers [W/ 44-845] -...

Great! Thanks for the info and quick reply!!

Hi, I found this set of 3 - 14mm, 17mm & 19mm hex sockets on ebay for $19.50. This will fit my 3/8" torque wrench, but I am concerned that the hex bit may be too short to remove the front wheel. They state the tool is 28mm long (just over 1"). I believe that is overall length, not just...

Hi, I ordered 2 new Dunlop Street Smart tires from Motorcycle-Superstore. I can't seem to find a bike shop in the Fort Lee, NJ or surrounding area, that can install the rubber. Any locals know of a reputable place, with good prices, that will do the rim removal and tire replacement...

Hmmm....good point. I did reseat the valve stem, poured soapy water on it (before and after) but no bubbles. I suspect the leak is too slow for bubbles to be produced in any quantity. Maybe I should replace the valve stem before trying the bead breaking? thanks for your input

Hi, I have approx 4K on the original Dunlop tires. There is still a lot of tread left, but the rear tire has developed a slow leak. I lose approx 10 PSI/week. I checked for punctures (nails etc) did the soapy water check, checked for rim damage and reseated the valve stem. Everything...

CLOSEOUT SPECIAL Puig Racing SMOKE Windscreen for FZ6 04-06 (34256) SoloMotoParts has this on sale: CLOSEOUT SPECIAL Puig Racing SMOKE Windscreen for FZ6 04-06 (34256) CLOSEOUT SPECIAL Puig Racing SMOKE Windscreen for FZ6 04-06 :: Parts Closeout :: Solo Moto Parts Hope this helps...

Well, I finally got adventurous and decided to mount the airhawk cushion under the seats' vinyl cover. After obtaining an electric staple gun from Lowes, I removed the fastening staples from the seat. It was apparent I just couldn't place the airhawk on the existing foam and recover it. I...

This post is worth a bump. Kudos to maverick1970 for his insightful solution. I too had bad vibration noise in the clutch handle. Today, I shaped a thin piece of plastic and inserted it as described above. The vibration noise is completely gone! So, with my grip puppies, airhawk seat and...

Hey D-Mac, check out this thread. Beads got good reviews too Five Motorcycle Seat Comfort Pads Compared - Accessories & Gear Review - Motorcycle Cruiser