Kill switch does not seem to have an issue fuel pump cycles on and off consistantly with press of kill switch. I pulled the start interrupter relay or the relay with 47 different names lol apart and found the casing had water in it and looks like this [picture below]
From my research code 19...
Thanks I will actually got the bike running earlier found there was a piece of the old pin stuck between 2 pins in the start cutout relay cleaned all that up and replaced the pin in the plug and she started and ran fine come back 3 hours later starts then dies with a code 19 on the dash now no...
Thank you for the response Gary the wiring on this bike is pretty janky so I think it would be advantageous to isolate the harness from components and check continuity and components lol I was trying to avoid getting into all that.
Just bought a 2012 fz6r today that sat outside in the elements. guy said there was no power to anything. I took her to an Autozone parking lot changed the 30 amp fuse on ignition relay then I have power to everything, but now I have a crank but no start with a flashing engine light upon cranking...