Recent content by helpmespeed

yes It is possible. I think i f-ed my cut off relay and so i finally foud the correct 2 wires and jumped them together. IT MOVED!!! I test drove it for an hour or so and Shee Hauls!!!! thanks everyone once again and thanks for this awesome website! couldnt have done it without the info!

Ok now i did it. I looked at the wiring diagram and i jumped the 2 wires and now shee wont crank, at all. OH $#!T!!!! but by far best diagram ive seen in months of looking, Thanks for the info, but now where do i go from? starter fuses good, efi fuse good, ignition fuse good. i might have fried...

nO clutch switch on my 94 banshee 600cc (2005 fz6 motor). can i bypass it on the harness somehow someone anyone? starts in neutral, butwhen going to shift in gears it dies out. i seen an r6 forum that you can bypass an r6. has anyone bypassed theirs??? thanks for the help so far!

hello i need to bypass mine. what color wires are they from the connectors????

Thanks again to all the gear heads in here, you all helped bring one of my crazy ideas to life!!! I finally got my lean angle sensor installed this evening after work and finally got my pump to prime. I will be testing it tomorrow hopefully! SHEE RUNS!!!!:thumbup::thumbup::thumbup::thumbup:

i still have the stand, it is hooked up and is in up position. my email is [email protected]. my name is Eric. Thanks again for the helpful hints guys

the harness is from a complete motor/frame combo with harness and also the ecu and regulator. i got the coils as well. i bought a throttle handle for the right side. includes kill/starter switch. Im almost certain it is the lean agle position sensor since there is computer chips in the sensor...

does anyone have a link to a full 2005 fz6 wire diagram??? i cant find a whole one anywhere. I do not have the tip sensor either.... The wiring harness is complete in nice condition no cuts. can i make the tip sensor eliminated? whAT wires do i cross to send the correct signal, i need a...

Hi everyone thanks for the input. i did smore searching and i found this awesomely amazing website i must share; http://fazershare.free.fr/upload/fz6/service%20manual%20-%20fz6%20-%20chapitre%206.pdf It had everything i needed to diagnose my low voltage at pump situation. it traced back...

Hello everyone! I broke down and joined this yamaha forum because i am stumped! i breath yamaha everything and ive read alot on here and learned so much so, PLEASE~HELPMESPEED!!!! Ok so last year my 94 banshee melted a lower rod bearing so i bought a 05 fz6 100HP motor and started over. almost a...