Domonics
New Member
Sorry if i am posting in the wrong area's (Or to much), anyhow,
Hey everyone!
New member here. I am having a strange issue. My 2005 FZ6 is making a noise like the ones in this forum:
https://www.600riders.com/forum/fz6-technical/56173-fz6-2006-knokcing-sound-when-rpms-go-down.html
There was never a resolution to this issue. The sound only is apparent after riding for about 30 minutes after everything is nice and warm. It makes the noise with the clutch in or out. The noise is most audible when engine breaking or when i rev and let off the throttle.in 1st, 2nd, and neutral (its probably making the noise in higher gears but hard to hear because of wind) Only seems to happen at the lower end of the deceleration, and happens in second and first when engine breaking on the higher end of the gear. and then in neutral after reving it and letting the RPMS drop back down.
I just replaced my oil and cam chain tensioner on the bike and did not notice anything abnormal or strange in the oil. I am thinking I may not have noticed the sound before because of the noise from the bad CCT?
I have put a pencil up to different parts of the motor and im having a hard time locating where exactly the noise is coming from. The closest i can get is that its coming from the left side by where the gear selector goes into the engine? or its coming from the left side between where the transmission and the pistons are in that little canyon. (if that makes sense)
The closest thing i can compare it to is it sounds like someone running their fingers on a plastic comb or the sound a diverter valve on a car makes when it is redirecting pressure (tingy knock unwinding noise)
Any ideas on what this could be?
I know many members have had the same issue and some say its a crank bearing (I should be able to hear it on start up right?)
Any advice or guidance would be extremely helpful.
Hey everyone!
New member here. I am having a strange issue. My 2005 FZ6 is making a noise like the ones in this forum:
https://www.600riders.com/forum/fz6-technical/56173-fz6-2006-knokcing-sound-when-rpms-go-down.html
There was never a resolution to this issue. The sound only is apparent after riding for about 30 minutes after everything is nice and warm. It makes the noise with the clutch in or out. The noise is most audible when engine breaking or when i rev and let off the throttle.in 1st, 2nd, and neutral (its probably making the noise in higher gears but hard to hear because of wind) Only seems to happen at the lower end of the deceleration, and happens in second and first when engine breaking on the higher end of the gear. and then in neutral after reving it and letting the RPMS drop back down.
I just replaced my oil and cam chain tensioner on the bike and did not notice anything abnormal or strange in the oil. I am thinking I may not have noticed the sound before because of the noise from the bad CCT?
I have put a pencil up to different parts of the motor and im having a hard time locating where exactly the noise is coming from. The closest i can get is that its coming from the left side by where the gear selector goes into the engine? or its coming from the left side between where the transmission and the pistons are in that little canyon. (if that makes sense)
The closest thing i can compare it to is it sounds like someone running their fingers on a plastic comb or the sound a diverter valve on a car makes when it is redirecting pressure (tingy knock unwinding noise)
Any ideas on what this could be?
I know many members have had the same issue and some say its a crank bearing (I should be able to hear it on start up right?)
Any advice or guidance would be extremely helpful.
Last edited: