stark23x
Junior Member
I've read about the mod one of the members here came up with for having working hi and low in each light. As far as I understand it, his mod does not cut into anything, correct? It's designed to work with the stock setup without cutting?
Thing is my stock wiring harness was already hacked up when I got the bike. The guy who owned it last hacked in an HID setup...an old one, and poorly done. I took it all out and wired in two sockets to return to basically stock. I added a connector inline to each side so I can easily swap to something else in the future.
My question is, could I split the green wire, sending one side to each H4 low beam filament, then split the yellow on the other side, doing the same going to the high? Would that give me two low beams at all times, then when I flip on the highs, cut off the low and turn on both highs?
Thing is my stock wiring harness was already hacked up when I got the bike. The guy who owned it last hacked in an HID setup...an old one, and poorly done. I took it all out and wired in two sockets to return to basically stock. I added a connector inline to each side so I can easily swap to something else in the future.
My question is, could I split the green wire, sending one side to each H4 low beam filament, then split the yellow on the other side, doing the same going to the high? Would that give me two low beams at all times, then when I flip on the highs, cut off the low and turn on both highs?