- Joined
- Feb 7, 2009
- Messages
- 12,532
- Reaction score
- 1,178
- Points
- 113
- Location
- Cape Coral, Florida, USA
Nope, no vice. I did all the work on my bench while it was loose. No clamps or anything.
It doesn't bolt to anything. Its for the slider pins.
Well, if everything else is on the money, I guess I'd have to look at the accuracy of that torque wrench..
Do you have another wrench you can compare it to?
Torquing down say a cage wheel stud to 40NM with another, known good wrench, then put THIS WRENCH on it and so if it goes further...
Be nice to know so if it is the issue, you don't break any other fasteners...