maverick1970
Super Member
- Joined
- Jan 21, 2008
- Messages
- 591
- Reaction score
- 6
- Points
- 0
- Location
- Jackson, Georgia, USA
SOLD
I'm selling the Ripper Mask (headlight) that I had on my StreetFighter. I bought this new from European Streetfighter, and believe me, it DID NOT come like you see on the website. I had to do A LOT of modifications to include making the mounting brackets, using a Dremel to cut out the holes on top of the Mask, and making the screened wire the correct bends for it to fit against the Mask
To install all you need are some fork mounts and to locate the high and low beam wires in the wiring harness. Cut them and replace with what ever connector you want. I used crimp on spade connectors. The fork mounts I used where these from Fly-N-Cycle. I recommend using them too because the holes in the mounting brackets are that width.
There's nothing wrong with it at all. You can see in the pictures a few scratches but that's it!!!!
Here is how it looked when I first received it in the mail.
I used a Dremel and sand paper to cut out the top parts of the Mask.
Fabricated the mounting brackets.
Here's the mask now that I'm selling.
Here are some pictures of when it was on my bike.
Asking $400.00
I'm selling the Ripper Mask (headlight) that I had on my StreetFighter. I bought this new from European Streetfighter, and believe me, it DID NOT come like you see on the website. I had to do A LOT of modifications to include making the mounting brackets, using a Dremel to cut out the holes on top of the Mask, and making the screened wire the correct bends for it to fit against the Mask
To install all you need are some fork mounts and to locate the high and low beam wires in the wiring harness. Cut them and replace with what ever connector you want. I used crimp on spade connectors. The fork mounts I used where these from Fly-N-Cycle. I recommend using them too because the holes in the mounting brackets are that width.
There's nothing wrong with it at all. You can see in the pictures a few scratches but that's it!!!!
Here is how it looked when I first received it in the mail.
I used a Dremel and sand paper to cut out the top parts of the Mask.
Fabricated the mounting brackets.
Here's the mask now that I'm selling.
Here are some pictures of when it was on my bike.
Asking $400.00
Last edited: