FE Problem

[aziebell]

I am installing my FE kit that I got. I removed the side pod and found all the wiring for the back signals and license plate light. Both signals have quick disconnects on them, but the license plate doesn't. There are only two wires encased in a rubber housing. So, my question would be how would I go about disconnecting the license plate light so I can get it off the bike?

 

[DownrangeFuture]

Those are bullet type connectors. They just pull apart. When you click them back together make sure to match wire colors.

Bullet connectors get kinda tight sometimes. WD-40 and let them soak for a minute if you think you're pulling hard enough to break the wires.

 

[aziebell]

Haha, I feel like an idiot now. Pulled apart with no problem. I was afraid I was going to break something, so I didn't want to try. Thanks

 

[DownrangeFuture]

It happens. No worries. :thumbup: