sandctrev
Junior Member
I purchased the VSO2 mod. My headlight lamp keeps burning out. I've wired correctly. Not sure what is going on. I would normally hit up Motogiro, but I've already bugged him today about a parallel issue.
Mod-head lamp keeps burning out.
- Thread starter sandctrev
- Start date
Two Questions:
1: Do you run high beam often?
2: If yes to 1; Have you installed a relay circuit to turn-off the low beam when switching to high beam?
1: Do you run high beam often?
2: If yes to 1; Have you installed a relay circuit to turn-off the low beam when switching to high beam?
- Joined
- May 8, 2008
- Messages
- 15,020
- Reaction score
- 1,194
- Points
- 113
- Location
- San Diego, Ca.
Any of you that has a question that I might be able to help you with can call me if you have my number. Remember I'm PST time zone....
Spencer, are you sure both filaments are not being supplied power? If they are both on at the same time the lamp will fail pretty quickly. They can both be on for only a few seconds before the lamp overheats and fails....
sandctrev
Junior Member
Both filements were running at the same time only when I had high beam on.
