ChanceCoats123
Junior Member
First, I just want to apologize if this is in the wrong section (I could think of at least three that it fits in).
So today I got the used PC3 that I bought and installed it right away. I first plugged it in to my computer (and stupid me), I didn't realize that it wasn't detected. So when I installed it, I was just running the zero map.
I took it for a ride, and had no issues what so ever.
I came back, plugged it into a different port on my laptop (which recognized it). So I was able to flash the Two Brothers Exhaust map from Dyno Jet (410-004).
Side note: When putting a new map on the bike, should I be sending the map or the table, or both? (I sent both).
Now, I took the bike for another ride and noticed smoother throttle response and what seemed like more power. :thumbup:
But I got home and turned the bike off. I decided I wanted to move it, so I went to restart the bike. It just cranked away and never fired back up. I know it's not a battery issue because after I had this problem, I flashed it back to the zero map and turned it off and on a few times without issue.
I did a little research prior to posting this, and found an older thread where the user had the same issue. He fixed it by adding 10 points of fuel to a few different spots on the map. I tried this same thing (I added 10 points to the 0% throttle by 500 rpm, 750rpm, and 1000rpm boxes (because that's basically where the bike is when cranking). It seemed to help, but I still have the issue occasionally.
tl:dr I installed a power commander 3 usb today and now the bike erratically starts only when hot.
So today I got the used PC3 that I bought and installed it right away. I first plugged it in to my computer (and stupid me), I didn't realize that it wasn't detected. So when I installed it, I was just running the zero map.
I took it for a ride, and had no issues what so ever.
I came back, plugged it into a different port on my laptop (which recognized it). So I was able to flash the Two Brothers Exhaust map from Dyno Jet (410-004).
Side note: When putting a new map on the bike, should I be sending the map or the table, or both? (I sent both).
Now, I took the bike for another ride and noticed smoother throttle response and what seemed like more power. :thumbup:
But I got home and turned the bike off. I decided I wanted to move it, so I went to restart the bike. It just cranked away and never fired back up. I know it's not a battery issue because after I had this problem, I flashed it back to the zero map and turned it off and on a few times without issue.
I did a little research prior to posting this, and found an older thread where the user had the same issue. He fixed it by adding 10 points of fuel to a few different spots on the map. I tried this same thing (I added 10 points to the 0% throttle by 500 rpm, 750rpm, and 1000rpm boxes (because that's basically where the bike is when cranking). It seemed to help, but I still have the issue occasionally.
tl:dr I installed a power commander 3 usb today and now the bike erratically starts only when hot.