Handlebars 22mm 7 8" Motorcycle Sport Bikes for Honda Yamaha Kawasaki Suzuki B K | eBay
So I'm looking at these and they look pretty cool, kind of like inverted clipons. Problem is, I don't know if they'll fit or if they'll work well on the FZ considering the buzziness of the bike.
Anybody...
I have a power commander on mine and at times it's still a bit choppy but way better than it use to be. I'm using Chances map whom also is a forum member. One of the veteran members looked it over with him and it's basically one of the maps from the power commander site but with 10% increase at...
I'm about to replace my brake pads and happened to come across this thread. Seems I should probably do the seals as well as the front isn't spinning freely.
Can I get these parts at my local autozone or do I need to order online?
I guess I need to get some more brake fluid as well as this...
Rotors feel smooth when running the finger over them. They look fine as far as I can tell.
I've recently replaced the tires so the rear and front came off a few weeks ago and the breaks haven't felt very good since. Pads are definitely worn but it was a significant loss of firmness to the...
I'd like some more bite to my braking and the front is definitely worn. Ofc anything new will feel awesome, I'm just saying that I wouldn't mind spending a few extra bucks on a better brand.
Is there anything else I should do other than clean/grease the calipers. Anything specific I should...
I saw you mentioned sea foam. I've used it twice on my bike before storing it and just after I bought it to clean the internals. I didn't really notice a difference post use.
Make sure all important nuts are torqed to spec, handlebars, axle nuts, engine mounts, drive train etc. You've...
Have you done a TB synch?
A lot of my vibration disappeared after doing it. Still vibry but that's because I have no bar ends. I ride it for about 1.30 h before my hands go numb
I noticed while syncing the TBs that my # TB was in more than the manual calls for. I believe someone mention it should be 3/4 to 1 full revolution out. Mine was between half and 3/4. Maybe I should redo the TB sync and move # out some to maybe a full revolution.
I'll probably install the PC3...
I'm having the same issue. Loopy idle and like the other guy I can't disconnect those connectors.
Once the bike warms up and I fiddle with the idle I can get it to almost perfect where it stays at 1380 and sounds great. Then I take it for a ride and 5 min in it starts looping again.
I've...