Hello & Welcome to our community. Is this your first visit? Register

Thanks Thanks:  14
Likes Likes:  2
Dislikes Dislikes:  0
Page 4 of 4 FirstFirst ... 234
Results 31 to 33 of 33
  1. #31
    FinalImpact (OP)
    2 Da Street, Knobs R Gone FinalImpact's Avatar
    Join Date
    Mar 2011
    USA, OR
    137 Post(s)
    1 Thread(s)
    Blog Entries

    Re: POST your Tune Map, Bazzaz, PCIII, PCV - AutoTune, Z-AFM

    Last years map on a Bazzaz made with a Z-AFM data logger. Do keep in mind header is S1 (no CAT), Mid-pipe is pass through, Exhaust is 2Bro open, Air box mod, timing advanced to 11.5 (stock is 5) and it has AIS block off plates. It runs out well.
    Map target is 13.0:1 AFR for anything over 10% TPS. 5% and closed are 12.9 and 12.7 at 0%. Its There is little to no perceivable throttle snatch. Blank spots means its fueling from the OEM ECU MAP.

    This is just snap shot of one ride logging results. I have since dialed in some of those values. Obviously with the throttle closed at 10K the AFR reads crazy but the engine isn't under load so it's not a concern.
    08 Raven w/a few mods...
    R6 Forks, R1 Rear Shock (revalved), 6 Ignition Advance, S1 CAT free Header, SS Mid-Pipe, 2Bro Exhaust, AIS block off plates, Bazzaz Z-Fi Fuel Controller & Z-AFM Data Logger, Air Box mod, CR10E Plugs, 48-Tooth Rear Sprocket, FZ1 Bars, Spider Grips, Adj levers, Powder Coated -Triple, Bars & Rear Sets, Solid mounted rear-sets w/knurled pegs, Dual Headlight, Tail Tidy, LED Combo Brake & Directionals, LED POD lights & Tinted PUIG Wind Screen!

  2. Likes Z3R0_zhift liked this post
  3. #32
    CQ CQ, DE KB2WYL POST your Tune Map, Bazzaz, PCIII, PCV - AutoTune, Z-AFM KB2WYL's Avatar
    Join Date
    Jul 2015
    Ferndale, CA
    1 Post(s)
    0 Thread(s)

    Re: POST your Tune Map, Bazzaz, PCIII, PCV - AutoTune, Z-AFM

    Well, I searched all the old threads. Few maps posted, that I already have, or are very similar. None of them from bikes with the trigger mod. @FinalImpact, is the pic of those cell settings still pretty close to what you're running? I know you have said you are still working it in, but I noticed this is the same pic in a few different threads. For mine, I would like to try it out at least. I have not been pleased (of course, wasn't expecting to be) with any of the other maps I've tried as they are all so far off from my bikes setup. But, your bike and mine are close.

    So, I can just copy the data manually into my cell structure. PCFC and Bazaaz set up the same way as far as that goes, just different files so I can't do it automatically via downloads.

    Aside from the map you have made with these cell settings, trying to achieve the 13.0, does the Bazzaz have any settings for the closed loop as well? The PCFC lets me adjust the entire closed loop as a whole, so I can trick the ECU into thinking that the O2 sensor is telling it more lean, or more rich, than it really is. If you're not altering that in yours, I'll try just setting it at zero. I have been getting fair results from setting it a little rich so far, but that's while running a zero map.


    Loren C.
    '07 FZ6. Dual headlight, Preload caps, Racetech springs, Airbox mod, AIS block off, K&N, De-cat mid-pipe, 2 Bros exhaust, Stock header w/ cat delete, 15T sprocket, Speedo healer, PCFC, Rearsets hard mounted, start switch disable w/hidden switch, Cramp Buster, Timing advanced 4 deg., Front turn signal flush mount, 2 Bros tail tidy, clutch slave lever extended, Mika Metals handlebars, Adjustable clutch+brake levers, Tech Spec tank grips and pad, 12v outlet

  4. #33
    Junior Member
    Join Date
    Jun 2017
    0 Post(s)
    0 Thread(s)

    Re: POST your Tune Map, Bazzaz, PCIII, PCV - AutoTune, Z-AFM

    All of the map threads I've found are very old and I haven't been able to find anything. I've got an 06 with a Leo, decat, and airbox mod. I'm hoping to find something close to mine so that I at least have a place to start.


Page 4 of 4 FirstFirst ... 234

Similar Threads

  1. PCV + Autotune. Do I need an o2 sensor?
    By GhengisT in forum FZ6 Performance Mods Section
    Replies: 5
    Last Post: 11-03-2014, 08:38 AM
  2. Dyno Tune or not to tune?
    By fz6king in forum FZ6 Mods
    Replies: 2
    Last Post: 06-12-2012, 11:41 PM
  3. Bazzaz FI Unit
    By S197 in forum FZ6 Mods
    Replies: 13
    Last Post: 08-01-2011, 10:58 AM
  4. PCV/Autotune and battery
    By REO Scorpio in forum Garage / Mechanical Help
    Replies: 5
    Last Post: 07-28-2010, 01:56 PM
  5. DynoJet AutoTune Module
    By BamaFZ6 in forum FZ6 Technical
    Replies: 3
    Last Post: 05-12-2010, 03:10 PM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
All times are GMT -7. The time now is 01:40 PM.
Image resizer by SevenSkins
Search Engine Optimisation provided by DragonByte SEO (Pro) - vBulletin Mods & Addons Copyright © 2019 DragonByte Technologies Ltd.
Feedback Buttons provided by Advanced Post Thanks / Like v3.6.3 (Lite) - vBulletin Mods & Addons Copyright © 2019 DragonByte Technologies Ltd.
User Alert System provided by Advanced User Tagging (Lite) - vBulletin Mods & Addons Copyright © 2019 DragonByte Technologies Ltd.
Copyright 2007 , All content is property of 600Riders.Com All Rights Reserved. The opinions and posts on this site do not neccesarily reflect those of the site owners or operators.
Yamaha FZ6 and Yamaha rights are property of Yamaha Motor Company. 600Riders.com is not associated with Yamaha in any way. We are an enthusiast site dedicated to the Yamaha FZ6 motorcycles. Our goal is to offer a place for Yamaha FZ6 owners to discuss rides, events, mods, maintenance, purchasing, etc
vBulletin Skin By: PurevB.com