Fender Eliminator ON THE CHEAP!!!

With the integrated light I began looking at the "sail" at the back of the bike and figured I'd see what I could do at no cost.

I ripped apart the rear fender and found I could use both the License mount and the sealed light. I dont have the light on yet, but heres the idea.

Too many expensive hobbies to spend on this stuff.
Gives me a sense of pride for having DIM, and works just the same.

Well done! Very clean. Looking forward to seeing it with plate light attached. Also take a pic from the side, please :thumbup:

Thanks Erci......

Will post a side shot once the lights on.

As promised....

Made a little beveled cylinder for the LED, mounted it inside a rear bracket.

And I think I may have found a way to recycle the fender, not %100 on it , yet it has the lines and color Im looking for. If I can get these LED bullets to flash I may mount them where the stock rear's were, only now up front that is.

Thanks to the EZ bake oven I found under the tree, the powder is flying thick!

We wouldnt get away with a tiny number plate like that here!