Naked FZ6 wire harness question.

A while back I converted my bike into a naked, but I've left the wire harness completely stock. I wrapped up the harness in electrical tape behing my little windscreen to protect it from the elements. But, I was wondering if there is a better product out there to protect the wire harness if I get stuck in a rain storm. Any help would be appreciated.

Thanks,
Nick

Unless you want to tidy up the wiring harness by rebuilding it, the only thing you might want to do is unplug every connector and put a generous glob of dielectric grease inside each one to make sure the weather stays out very good.

i think the safest option, is just to tape it all up very snugly, lots of tape, then cable tie the lot up under the instrument panel as best you can....

:thumbup:

Thanks for the advice guys. I think I'll re-tape and tidy it up.

Thanks,
Nick

Tidy up the front end and better protect the connectors, by moving all that excess harness length to the under tank area!