When I start my fz6 from cold I blip the throttle and it almost sounds like its running on only a few cylinders I think it idles fine its just when I rev a little, if I leave it a minute or two it starts to rev fine. Im new to 600's and just wanted to know if this is normal. Its done 26k miles...
Hey guys, having a minor issue with my S1 lately. Quick backstory/breakdown...
Bought bike in June 2017 with just over 21,000 miles (22,300 on it now), ran through most maintenance i could think of (replace brake fluid, replaced coolant, checked oil, air filter, etc etc) A few weeks after...
I'm sorry for the abrupt question, but I just had a hell of an afternoon. I tried to do a spark plug change for my bike, and I'm not sure why, but after it was all installed, the idle was really rough and something was obviously wrong (the bike was jerking and misfiring, it seems). I ripped it...
Long story short.
I've been chasing a vib, very high frequency,definitly engine RPM related.
After many checks, adjustments, re-setting engine position-torque, sync, etc, I found the issue...
After doing a spark plug wire shortening(didn't need it, no arcing, two slightly loose) I...
im in the process of streetfightering a 2006 fz6 and also installing a clear taillight. So i removed the side panels and took off the tail. But i did not notice where all the wires in the left side panel are suppose to connect to. I have the two plugs that go to the turn signals, and two plugs...
Hi there fellow bikers, I did or thought I'd posted earlier but I can't find it so I'm guessing I didn't post it.
My '98 FZS600 probably hasn't had a service in a while as the plugs were rusty and in desperate need of change so I've done the plugs, oil, oil filter and next will be the air...
I recently went over 100,000 miles on my FZ6. I bought it new in April of 2009 as a leftover 2008 model. I use non-synthetic oil and change about every 4000 miles. Here is a condensed highlight of some of the bigger maintenance items during that time:
26,464 miles: brake fluid, coolant...
Hi All,
My 2006 FZ6 has been running rough for about 2 months. I searched the Forum and hoped I just had some bad gas. She has just over 7K miles. I took her out for a little jaunt and she was running more rough. I stopped by the only Yamaha/Honda Dealer around and inquired at the...
As the title says, I swapped out my old stock spark plugs (overdue for both years and mileage) for some long life Iridiums. As per reading, I didn't gap them at all - just plug and play. Old plugs were obviously used, but were otherwise in good condition and didn't appear to have been fouled in...
Not that I'm looking to sell the Hot Raven Chick but the question goes out, what would you pay for her as is? Share your thoughts!
Let me say that she will either leave us as a crash victim or be sold as is. I'm not into taking it all apart!
With some level of certainty, I'm sure some wise...
So last week I dropped my tank and it pulled the wire out of the terminals and broke both connector plugs. Not a big deal I figured but I am having a difficult time finding the proper replacements that fit correctly.
Does anyone know an aftermarket or OEM part# that I can purchase that will...
Last weekend while adding an USB port to my fairing my tank slid off and broke my fuel line and pulled the wiring out of the electrical plugs. I have been having a hard time finding replacements plugs.
What I am really needing is the plugs with a pigtail. If anyone could help me out that...
Hi,
I'm needing to get a roadworthy for my FZ6N 08, but I've turned the shed upside down and can't find the silencer plugs for the Micron cans.
If anyone in Brisbane has a pair they'd like to lend out for $50, that'd save my life.
Or point me in the direction of a RWC guy who's not...
Hi, I'm complaining to fuel consumption of my fazer. I'm thinking to upgrade the spark plugs to iridium ones and sync the t. bodies.
I just replaced plugs before 3k miles with cr9ek. air filter is oem, if I install the k&n, consumption increases. I believe tb sync is way off or bike is too lean...