Right. my fz6 has problem on idle when reached operating temperature so i started do some work on it.
1. new ignition coils ( was 3.8 ohms)
2. new timing chain (2-3 mm rotor mark was out.)
3. Valve clearance. ( 3 shims from exhaust needed new. 0.36, 0.32 and 0.21 mm) Now all of them are in...
What you guys using for throttle balance? I bought some gauges and they show me very weird measurment. Like I have vacuum power of 9 and 8 where should be like 20.... something. Any accurate tool?
Hello gents. I had quite big job to do. (Valve clearance) I disconnected all radiator. Usually I write everything down but I forgot about other end. On throttle body we have 2 cooling pipes. One going to the radiator one down engine. Can eny one tell me the bottom or top going radiator when you...
Rubbers looks good i looked into spark plug holes and it's looks clear. I removed ignition coil, caps and I check them for resistance. All in tolerance except one. Primary resistance shows 3.8 ohms on both in 10celcius where tolerance is 1.53 to 2.07 ohms @20 Celsius
so basically when i wash my motorbike or rain catch me up my motorbike are misfiring. Loosing power and silly noises coming up from my motorbike when i try put him on revs. any ideas? suggestions.. ?