Recent content by AlisAquilae

Everything has sold. Thanks.

Bump - mirrors are sold.

fz6-Dan - I apologize for the late reply, I'm not receiving notification emails for this thread for some reason. Yes, I have both mole 1 and mole 2, they are still attached to the front fairing but I'm happy to take them off and sell them separately. Are you interested? Mole 1 looks brand new...

fz6-Dan - can you show me a link to a picture of those parts? I'm not certain which ones you're talking about. Nelly - I'm sorry, no handlebars for sale.

I am asking $20 each but since there are a few light scratches on them, I'll cover the shipping. .

Parts off the front end of a 2009 Yamaha FZ6 for sale. All component are used but in good condition. These were taken off when I went to a naked front end conversion. All prices are OBO + actual shipping costs. Reference here for part numbers...

I've got an '09 headlight assembly in excellent condition - no scratches or other damage. One bulb is missing though, it was removed by the previous owner to use for his streetfighter build. Let me know if you can use this and we can work out a deal. Thanks.

Replaced all four plugs with CR9Es and everything works great! I had about two gallons left in the tank and added two ounces of seafoam to it as an added measure. The combination of these two fixes has really cleared up any issues that my FZ6 was having - cylinder misfiring, sluggish...

Gotcha: set closer to 0.024" per the manual's range of 0.024"-0.028". Wasn't too bad at all - luckily I happened to have a 14mm combo wrench on hand that I bought separately to change the front driveshaft u-joint in my truck. My socket and wrench sets are shipped to my new job site and I do not...

I pulled the plugs earlier today and found the following: #2 plug in #2 boot gives no spark #2 plug in #4 boot gives no spark #4 plug in #4 boot gives spark #4 plug in #2 boot gives spark #2 plug and #4 plug look the same I've drawn the conclusion that the only component broken is #2 plug. #2...

Will do. I just read this write-up (How to: Replace your sparkplugs in 20 minutes - Sportbikes.net) on how to remove the plugs and the process is much shorter than I had anticipated. I'll look at the plugs tomorrow and report back with some pictures. Thanks for the replies.

1. Trailer is enclosed and locked so I don't think it could have been tampered with. 2. It will be a week or two before i have the opportunity to pull the plugs due to traveling. I will try to post results when I do. Are these the iridium plugs you are suggesting?: NGK Spark Plugs USA...

Thanks for the reply! 8500 miles, valves have never been checked. To clarify, you are suggesting as a first step that I check the plugs/wires and go ahead an replace all plugs while I have them apart? I included the anecdote about trailering because I was wondering if the vibrations/jolts from...

Hello, I just trailered my FZ6 1100 miles to the site of my new job. On the first ride after taking it off the trailer, I noticed that the exhaust note was significantly different than usual, the bike had trouble accelerating and power felt low. I rode around for about half an hour, then...

Thanks, I will plan to take those steps within the next few weeks here as time and weather permits. Lots of rain in my area lately and I have to work outside in the parking lot. To answer your question: Yes, it pulls strong from 8-12K (and also anywhere else above 5K) just like it did when I...